FERTILUQ TAMPÓN

4% w/w total Nitrogen (N).

4% w/w ureic nitrogen (N).

25% w/w Water-soluble Phosphorus Pentoxide (P₂O₅).

FERTILUQ TAMPÓN is an NP fertiliser solution, providing these two essential nutrients for plant growth.

Its high phosphorus content makes it particularly suitable for promoting flowering and fruit set in all types of crops.

Phosphorus is a macronutrient that plays a role in the transport, storage and transfer of energy in crops.

Due to its acidity, FERTILUQ TAMPÓN can also be used to regulate the pH of alkaline water used in foliar application treatments.

Apply as a standard foliar spray at a rate of 100 cm³ per hectolitre.

For fruit trees, apply before flowering and after fruit set.

For vegetable crops, apply once four true leaves have appeared and after the first fruit set.

If you wish to make use of its pH buffering capacity, please follow these instructions:

1) Fill the spray tank with clean water to the desired level.

2) Slowly add FERTILUQ TAMPÓN to the water until the pH is adjusted to between 6 and 6.5, using the doses indicated in the table below.

Table of indicative pH values obtained according to the dose of FERTILUQ TAMPÓN applied:

3) Once the pH has been adjusted, add the remaining products to be used.

To check the effectiveness of this product, dip the pH indicator strips included in the pack into the water in the spray tank for a few seconds — once before and once after adding FERTILUQ TAMPÓN — and check the pH value obtained by comparing the colour of the strips with the colours corresponding to each pH value shown below.

The test strips are for single use only.

As with any foliar treatment, avoid applying the product while temperatures are high or in strong sunlight.

For further information, please contact our Agricultural Technical Department.